Thomas Peterson: Created page with "ECU software updates must be performed with the engine off. The three co processors are updated separately. File:Ecu-usbs.jpg #Place the update hex file or files on a USB drive that is formatted FAT. ##Speed controller updates will start with “Gov…” ##Ignition updates will start with “IIC…” ##AFR updates will be called “AFRC_ADV.hex” #Open the small cover on the front of the ECU #Insert the drive into the appropriate USB port ##From left to right,..."

2022-07-29T19:56:10Z

Created page with "ECU software updates must be performed with the engine off. The three co processors are updated separately. File:Ecu-usbs.jpg #Place the update hex file or files on a USB drive that is formatted FAT. ##Speed controller updates will start with “Gov…” ##Ignition updates will start with “IIC…” ##AFR updates will be called “AFRC_ADV.hex” #Open the small cover on the front of the ECU #Insert the drive into the appropriate USB port ##From left to right,..."

New page

ECU software updates must be performed with the engine off. The three co processors are updated separately.

[[File:Ecu-usbs.jpg]]

#Place the update hex file or files on a USB drive that is formatted FAT.
##Speed controller updates will start with “Gov…”
##Ignition updates will start with “IIC…”
##AFR updates will be called “AFRC_ADV.hex”
#Open the small cover on the front of the ECU
#Insert the drive into the appropriate USB port
##From left to right, the ports are Ignition, Speed, AFRC
#Press the reset switch above the USB ports
#Wait about 20 seconds for the update to complete
#Remove USB drive
#Re-attach cover securely to prevent leaks

Warning : Do not over tighten the nuts on the cover or the studs could break off

The update can be checked on the page “Information” -> “Software Versions” of the DCT to verify the new version has uploaded.

ECU Software Updates - Revision history