Thomas Peterson at 17:43, 31 January 2024

2024-01-31T17:43:47Z

← Older revision		Revision as of 17:43, 31 January 2024
Line 1:		Line 1:
	The EMIT vibration sensor can be wired as a 4-20mA sensor or using a CAN bus. Benefits of using the CAN bus are (1) the panel analog inputs won't be consumed and (2) more detailed data and information will be available.		The EMIT vibration sensor can be wired as a 4-20mA sensor or using a CAN bus. Benefits of using the CAN bus are (1) the panel analog inputs won't be consumed and (2) more detailed data and information will be available.

	As mentioned in the [[Vibration Sensor Manual]], to wire via CAN the connection must make a single daisy-chain from the panel to each sensor. If a sensor is the end of the chain (only one wire goes into each terminal) then the red termination switch will be ON (to inside). If a sensor is in the middle of a chain (wires go in and out of each terminal) then the red termination switch will be OFF (to outside). Several examples are shown below to help illustrate this idea.		As mentioned in the [[Vibration Sensor Manual]], to wire via CAN the connection must make a single daisy-chain from the panel to each sensor. If a sensor is the end of the chain (only one wire goes into each terminal) then the red termination switch will be ON (to inside). If a sensor is in the middle of a chain (wires go in and out of each terminal) then the red termination switch will be OFF (to outside). Several examples are shown below to help illustrate this idea. The enclosures are not shown for cleanliness. In the panel the CAN H and CAN L will ultimately route to the last module in the panel CAN chain (For example, the Brain if it was the current end of the chain).

			[[File:Vib 1.png\|300px]]

			[[File:Vib 2.png\|600px]]

			[[File:Vib 3.png\|900px]]

Thomas Peterson: Created page with "The EMIT vibration sensor can be wired as a 4-20mA sensor or using a CAN bus. Benefits of using the CAN bus are (1) the panel analog inputs won't be consumed and (2) more detailed data and information will be available. As mentioned in the Vibration Sensor Manual, to wire via CAN the connection must make a single daisy-chain from the panel to each sensor. If a sensor is the end of the chain (only one wire goes into each terminal) then the red termination switch wil..."

2024-01-31T17:40:56Z

Created page with "The EMIT vibration sensor can be wired as a 4-20mA sensor or using a CAN bus. Benefits of using the CAN bus are (1) the panel analog inputs won't be consumed and (2) more detailed data and information will be available. As mentioned in the Vibration Sensor Manual, to wire via CAN the connection must make a single daisy-chain from the panel to each sensor. If a sensor is the end of the chain (only one wire goes into each terminal) then the red termination switch wil..."

New page

The EMIT vibration sensor can be wired as a 4-20mA sensor or using a CAN bus. Benefits of using the CAN bus are (1) the panel analog inputs won't be consumed and (2) more detailed data and information will be available.

As mentioned in the [[Vibration Sensor Manual]], to wire via CAN the connection must make a single daisy-chain from the panel to each sensor. If a sensor is the end of the chain (only one wire goes into each terminal) then the red termination switch will be ON (to inside). If a sensor is in the middle of a chain (wires go in and out of each terminal) then the red termination switch will be OFF (to outside). Several examples are shown below to help illustrate this idea.

Vibration Sensor CAN Wiring - Revision history

Thomas Peterson at 17:43, 31 January 2024