ECU Software Updates
From EMIT Controls
Revision as of 19:56, 29 July 2022 by Thomas Peterson (talk | contribs) (Created page with "ECU software updates must be performed with the engine off. The three co processors are updated separately. File:Ecu-usbs.jpg #Place the update hex file or files on a USB drive that is formatted FAT. ##Speed controller updates will start with “Gov…” ##Ignition updates will start with “IIC…” ##AFR updates will be called “AFRC_ADV.hex” #Open the small cover on the front of the ECU #Insert the drive into the appropriate USB port ##From left to right,...")
ECU software updates must be performed with the engine off. The three co processors are updated separately.
- Place the update hex file or files on a USB drive that is formatted FAT.
- Speed controller updates will start with “Gov…”
- Ignition updates will start with “IIC…”
- AFR updates will be called “AFRC_ADV.hex”
- Open the small cover on the front of the ECU
- Insert the drive into the appropriate USB port
- From left to right, the ports are Ignition, Speed, AFRC
- Press the reset switch above the USB ports
- Wait about 20 seconds for the update to complete
- Remove USB drive
- Re-attach cover securely to prevent leaks
Warning : Do not over tighten the nuts on the cover or the studs could break off
The update can be checked on the page “Information” -> “Software Versions” of the DCT to verify the new version has uploaded.
