http://data.emittechnologies.com/wiki/index.php?action=history&feed=atom&title=Default_Panel_Settings_for_EDRsDefault Panel Settings for EDRs - Revision history2026-05-05T19:42:24ZRevision history for this page on the wikiMediaWiki 1.38.2http://data.emittechnologies.com/wiki/index.php?title=Default_Panel_Settings_for_EDRs&diff=582&oldid=prevThomas Peterson: Created page with "When installing an EDR on a panel, find the panel type below and use the settings listed to make sure the EDR can communicate with the panel. ===EMIT EIM=== Under System Settings, navigate to "Modbus". The settings should be: *Communications: 9600,N,8,1 *EIM ID: 10 *Annunciator ID: 70 *EDT ID: 80 ===Altronic DE-3000=== Go to “EDIT SAFETY SHUTDOWNS” -> “MORE MENUS” -> “COMMUNICATIONS”. *NODE should be “1” *PORT 1 is not relevant *PORT 3 should be..."2022-07-29T17:20:24Z<p>Created page with "When installing an EDR on a panel, find the panel type below and use the settings listed to make sure the EDR can communicate with the panel. ===EMIT EIM=== Under System Settings, navigate to "Modbus". The settings should be: *Communications: 9600,N,8,1 *EIM ID: 10 *Annunciator ID: 70 *EDT ID: 80 ===Altronic DE-3000=== Go to “EDIT SAFETY SHUTDOWNS” -> “MORE MENUS” -> “COMMUNICATIONS”. *NODE should be “1” *PORT 1 is not relevant *PORT 3 should be..."</p>
<p><b>New page</b></p><div>When installing an EDR on a panel, find the panel type below and use the settings listed to make sure the EDR can communicate with the panel.<br />
<br />
===EMIT EIM===<br />
<br />
Under System Settings, navigate to "Modbus".<br />
<br />
The settings should be:<br />
<br />
*Communications: 9600,N,8,1<br />
*EIM ID: 10<br />
*Annunciator ID: 70<br />
*EDT ID: 80<br />
<br />
===Altronic DE-3000===<br />
<br />
Go to “EDIT SAFETY SHUTDOWNS” -> “MORE MENUS” -> “COMMUNICATIONS”.<br />
<br />
*NODE should be “1”<br />
*PORT 1 is not relevant<br />
*PORT 3 should be “MODBUS 9600”<br />
<br />
[[File:De3000-setup.png]]<br />
<br />
===Altronic DD-40===<br />
<br />
*PROGRAM SERIAL MODE (at top PROGM) should be set to “485” (not “A 485”)<br />
*PROGRAM BAUD RATE should be set to "b:9600"<br />
*PROGRAM NODE NUMBER (at top PROGM next menu after baud) should be set to "01"<br />
<br />
===Murphy TTD===<br />
<br />
*“rtu” should be set to “1”<br />
*“Port” should be set to “0” (RS485)<br />
*“baud” should be set to “0” (9600,N,8,1)<br />
<br />
[[File:Ttd-config.PNG]]<br />
<br />
===Murphy Centurion===<br />
<br />
Under MISCELLANEOUS SETUP:<br />
<br />
*Ctrl Port 2 Mode should be set to “RS485”<br />
*Ctrl Port 2 Baud Rate should be set to “9600”</div>Thomas Peterson