Thomas Peterson at 17:28, 4 August 2022

2022-08-04T17:28:33Z

← Older revision		Revision as of 17:28, 4 August 2022
Line 18:		Line 18:
	This page appears as follows:		This page appears as follows:

	[[File:~~Ethernet Setup~~.~~jpg~~]]		[[File:Eim-ethernet.png]]

	There are two IP address setup options:		There are two IP address setup options:

Sean Sanders: /* Ethernet Setup Page */

2022-08-02T20:59:14Z

Ethernet Setup Page

← Older revision		Revision as of 20:59, 2 August 2022
Line 18:		Line 18:
	This page appears as follows:		This page appears as follows:

	<nowiki></nowiki>Insert Image		[[File:Ethernet Setup.jpg]]

	There are two IP address setup options:		There are two IP address setup options:

Sean Sanders: Sean Sanders moved page Ethernet to EIM Ethernet

2022-07-26T17:57:14Z

Sean Sanders moved page Ethernet to EIM Ethernet

← Older revision	Revision as of 17:57, 26 July 2022
(No difference)

Sean Sanders: Created page with "=== Overview === Some EIMs have an ethernet port on the back that can be connected to a customer network. The following serial number ranges have an ethernet port: * 1000 - 1899 * 3203 and newer The following functions are currently supported by the ethernet port: * Modbus TCP (EIM Versions 1.89 and later) Other functions, such as file transfers and remote web access, may be supported in the future. This page covers the setup of the ethernet port. === Ethernet Setu..."

2022-07-21T17:00:09Z

Created page with "=== Overview === Some EIMs have an ethernet port on the back that can be connected to a customer network. The following serial number ranges have an ethernet port: * 1000 - 1899 * 3203 and newer The following functions are currently supported by the ethernet port: * Modbus TCP (EIM Versions 1.89 and later) Other functions, such as file transfers and remote web access, may be supported in the future. This page covers the setup of the ethernet port. === Ethernet Setu..."

New page

=== Overview ===
Some EIMs have an ethernet port on the back that can be connected to a customer network. The following serial number ranges have an ethernet port:

* 1000 - 1899
* 3203 and newer

The following functions are currently supported by the ethernet port:

* Modbus TCP (EIM Versions 1.89 and later)

Other functions, such as file transfers and remote web access, may be supported in the future.

This page covers the setup of the ethernet port.

=== Ethernet Setup Page ===
If the EIM has an ethernet port, and if the kernel version has been updated to support ethernet, a page will be available to setup the IP Address. This page will be found from the System Menu at "System Settings" -> "Ethernet Port". The button will only show up if the kernel and software support ethernet.

This page appears as follows:

<nowiki>*</nowiki>Insert Image*

There are two IP address setup options:

* DHCP: This option will cause the port to request an automatic address. The current address can be seen under "Port Status"
* Manual: This option causes buttons to pop up allowing manual entry of the IP Address, Gateway, and Subnet Mask. If an address is entered in this way, the address must be properly covered by the gateway for "Submit" to accept the settings.

Separately, there is a setting for the Modbus/TCP port. If a different port is needed than the default port, it can be entered here.

After choosing the settings, select "Submit". If the page validates, the network port should update. Sometimes a power cycle may be required.

EIM Ethernet - Revision history

Thomas Peterson at 17:28, 4 August 2022

Sean Sanders: /* Ethernet Setup Page */

Sean Sanders: Sean Sanders moved page Ethernet to EIM Ethernet