CAN Terminations With CAT Panel: Revision history

From EMIT Controls

Diff selection: Mark the radio buttons of the revisions to compare and hit enter or the button at the bottom.
Legend: (cur) = difference with latest revision, (prev) = difference with preceding revision, m = minor edit.

    19 August 2022

    • curprev 21:4821:48, 19 August 2022‎ Thomas Peterson talk contribs‎ 1,179 bytes +1,179‎ Created page with "Any CAN bus will need a resistor termination on the two ends. The bus might daisy-chained to many places but there should be exactly two termination at the ends. On a stock CAT engine there will be a termination plug by the ECU on the engine and another inside the panel box. (Note: Some engines have two busses so there are another two terminations somewhere). When the EDR, EDT, or DCT is added and connected to the CAN bus then the EMIT module becomes the end of the bus..."
Retrieved from "http://data.emittechnologies.com/wiki/index.php?title=CAN_Terminations_With_CAT_Panel"