Speed Sensor Setup: Difference between revisions
From EMIT Controls
Sean Sanders (talk | contribs) m (Sean Sanders moved page Sensor Setup to Speed Sensor Setup) |
No edit summary |
||
| Line 1: | Line 1: | ||
The | The Speed Controller Sensor Setup page specifies the pressure sensor settings. An access level of Setup or higher is needed to see this screen. | ||
This page will not be used if an EMIT Brain / Annunciator is connected, since in that case the sensors are set up through the Brain instead. | |||
For each sensor used, specify the low and high PSI value that corresponds to the input that causes an output of 4mA and 20mA respectively. This information can be found stamped on the sensor itself. | For each sensor used, specify the low and high PSI value that corresponds to the input that causes an output of 4mA and 20mA respectively. This information can be found stamped on the sensor itself. | ||
Latest revision as of 21:57, 29 July 2022
The Speed Controller Sensor Setup page specifies the pressure sensor settings. An access level of Setup or higher is needed to see this screen.
This page will not be used if an EMIT Brain / Annunciator is connected, since in that case the sensors are set up through the Brain instead.
For each sensor used, specify the low and high PSI value that corresponds to the input that causes an output of 4mA and 20mA respectively. This information can be found stamped on the sensor itself.
