Annunciator Output Testing: Difference between revisions

From EMIT Controls
No edit summary
No edit summary
 
(4 intermediate revisions by 2 users not shown)
Line 1: Line 1:
=== Overview ===
=== Digital Out Testing===
The annunciator digital out test screen is used to test the digital outputs (especially during install).
The digital out test screen is used to test the digital outputs (especially during install).


The screen is reached from the annunciator home page by selecting "Annunciator Setup" -> "Annunciator Output Status / Testing" -> "Digital Out Testing"  
The screen is reached from the home page by selecting Settings -> Brain -> "Output Status / Testing" -> "Digital Out Testing"  


To use this page, the annunciator must be in a stopped state. Select "Force ON" or "Force OFF" to force an output to that level for testing.
[[File:Core Test Digital Out.jpg]]


Select "Clear Test / Done" to remove all forced commands and return the outputs to their normal state. (Note: Some outputs will still be normally on when the annunciator is stopped, such as hot start).
To use this page, the system must be in a stopped state. Select "Force ON" or "Force OFF" to force an output to that level for testing.
 
Select "Clear Test / Done" to remove all forced commands and return the outputs to their normal state. (Note: Some outputs will still be normally on when the unit is stopped, such as hot start).


If "RESET" or "STOP" is ever pressed on the panel, all forced output states will be cleared immediately.
If "RESET" or "STOP" is ever pressed on the panel, all forced output states will be cleared immediately.
===Analog Out Testing===
There is an analog output test page under Settings -> Brain -> "Output Status / Testing" -> "Analog Out Testing". It can be used for testing both Brain and Brain+ outputs.
Depending on if an output is in voltage or current mode, a row for each output will give an option to force to several V or mA values. Press an option to force that value, then press "Clear Test" when done.

Latest revision as of 22:00, 5 August 2022

Digital Out Testing

The digital out test screen is used to test the digital outputs (especially during install).

The screen is reached from the home page by selecting Settings -> Brain -> "Output Status / Testing" -> "Digital Out Testing"

Core Test Digital Out.jpg

To use this page, the system must be in a stopped state. Select "Force ON" or "Force OFF" to force an output to that level for testing.

Select "Clear Test / Done" to remove all forced commands and return the outputs to their normal state. (Note: Some outputs will still be normally on when the unit is stopped, such as hot start).

If "RESET" or "STOP" is ever pressed on the panel, all forced output states will be cleared immediately.

Analog Out Testing

There is an analog output test page under Settings -> Brain -> "Output Status / Testing" -> "Analog Out Testing". It can be used for testing both Brain and Brain+ outputs.

Depending on if an output is in voltage or current mode, a row for each output will give an option to force to several V or mA values. Press an option to force that value, then press "Clear Test" when done.