DCT Password Levels: Difference between revisions
From EMIT Controls
(Created page with "The DCT has three password levels: read-only, Setup, and Engineering. The list below shows which settings groups are included under each level. ==Settings that can be changed under read-only== *PID Setpoint/Deadband (if enabled on PID setup page) *Speed setpoint ==Settings that can be changed under Setup== *Engine hour timers reset *AFRC Alarms *Analog input kills (but not sensor settings) *B timer lengths *Buzzer alarm *Custom digital output criteria ==Settings t...") |
No edit summary |
||
| Line 11: | Line 11: | ||
*AFRC Alarms | *AFRC Alarms | ||
*Analog input kills (but not sensor settings) | *Analog input kills (but not sensor settings) | ||
*Digital input setup | |||
*B timer lengths | *B timer lengths | ||
*Buzzer alarm | *Buzzer alarm | ||
*Custom digital output criteria | *Custom digital output criteria | ||
*Brain ECU selection | |||
*Gauge setup | |||
*Idle hold settings | |||
*Speed alarms | |||
*Load delay settings | |||
*Pre/Post lube settings | |||
*Noflow settings | |||
*Recycle loop settings (some settings) | |||
*Speed de-rate settings | |||
*Start gas settings | |||
*Thermocouple input kills | |||
*EMIT Ignition alarms, calibration, timing setup | |||
*EMIT Speed controller Alarm setup, idle hold setup, sensor setup, calibration | |||
*EMIT Vibration sensor kill level | |||
Revision as of 21:45, 6 February 2023
The DCT has three password levels: read-only, Setup, and Engineering. The list below shows which settings groups are included under each level.
Settings that can be changed under read-only
- PID Setpoint/Deadband (if enabled on PID setup page)
- Speed setpoint
Settings that can be changed under Setup
- Engine hour timers reset
- AFRC Alarms
- Analog input kills (but not sensor settings)
- Digital input setup
- B timer lengths
- Buzzer alarm
- Custom digital output criteria
- Brain ECU selection
- Gauge setup
- Idle hold settings
- Speed alarms
- Load delay settings
- Pre/Post lube settings
- Noflow settings
- Recycle loop settings (some settings)
- Speed de-rate settings
- Start gas settings
- Thermocouple input kills
- EMIT Ignition alarms, calibration, timing setup
- EMIT Speed controller Alarm setup, idle hold setup, sensor setup, calibration
- EMIT Vibration sensor kill level
Settings that can be changed under Engineering
Everything else
