Annunciator Output Testing: Difference between revisions
m (Thomas Peterson moved page Annunciator Digital Out Test Screen to Annunciator Output Testing without leaving a redirect) |
No edit summary |
||
| Line 1: | Line 1: | ||
=== | === Digital Out Testing=== | ||
The digital out test screen is used to test the digital outputs (especially during install). | The digital out test screen is used to test the digital outputs (especially during install). | ||
| Line 11: | Line 11: | ||
If "RESET" or "STOP" is ever pressed on the panel, all forced output states will be cleared immediately. | If "RESET" or "STOP" is ever pressed on the panel, all forced output states will be cleared immediately. | ||
===Analog Out Testing=== | |||
There is an analog output test page under Settings -> Brain -> "Output Status / Testing" -> "Analog Out Testing". It can be used for testing both Brain and Brain+ outputs. | |||
Depending on if an output is in voltage or current mode, a row for each output will give an option to force to several V or mA values. Press an option to force that value, then press "Clear Test" when done. | |||
Latest revision as of 22:00, 5 August 2022
Digital Out Testing
The digital out test screen is used to test the digital outputs (especially during install).
The screen is reached from the home page by selecting Settings -> Brain -> "Output Status / Testing" -> "Digital Out Testing"
To use this page, the system must be in a stopped state. Select "Force ON" or "Force OFF" to force an output to that level for testing.
Select "Clear Test / Done" to remove all forced commands and return the outputs to their normal state. (Note: Some outputs will still be normally on when the unit is stopped, such as hot start).
If "RESET" or "STOP" is ever pressed on the panel, all forced output states will be cleared immediately.
Analog Out Testing
There is an analog output test page under Settings -> Brain -> "Output Status / Testing" -> "Analog Out Testing". It can be used for testing both Brain and Brain+ outputs.
Depending on if an output is in voltage or current mode, a row for each output will give an option to force to several V or mA values. Press an option to force that value, then press "Clear Test" when done.
