DCT Password Levels

The DCT has three password levels: read-only, Setup, and Engineering. The list below shows which settings groups are included under each level.

The passwords can be changed under System Settings - Change Passwords. See this link for details.

Optionally, the Engineering level can be locked out to require a USB security key. See EIM_Security_Key

Note: some uncommon settings are not shown

Settings that can be changed under read-only

• PID Setpoint/Deadband (if enabled on PID setup page)
• Speed setpoint

Settings that can be changed under Setup

• Engine hour timers reset
• AFRC Alarms
• Analog input kills (but not sensor settings)
• Digital input setup
• B timer lengths
• Buzzer alarm
• Custom digital output criteria
• Brain ECU selection
• Gauge setup
• Idle hold settings
• Speed alarms
• Load delay settings
• Pre/Post lube settings
• Noflow settings
• Recycle loop settings (some settings)
• Speed de-rate settings
• Start gas settings
• Thermocouple input kills
• EMIT Ignition alarms, calibration, timing setup
• EMIT Speed controller Alarm setup, idle hold setup, sensor setup, calibration
• EMIT Vibration sensor kill level

Settings that can be changed under Engineering

All settings can be changed under engineering. Summary of items not above:

• Analog input sensor settings
• PID loop detailed settings
• Recycle loop detailed settings
• Crank setup
• Bypass and blowdown settings
• Start permissive
• Input calibrations
• Purge settings
• Remote switch setup
• Screw load settings
• Valve setup
• EMIT Ignition main setup and engineering setup
• EMIT Speed controller main setup, engineering setup, pid setup