EDR Troubleshooting - Incorrect callout descriptions
From EMIT Controls
Revision as of 17:10, 2 July 2024 by Thomas Peterson (talk | contribs) (Created page with "Symptom: Callouts are being sent normally but the description is not correct '''Verify Fault Code Table''' 1. Connect to the EDR wifi console. Instructions can be found here: EDR Wi-Fi Console 2. Go to the “Alerts” tab of the console 3. Open the “Shutdown Code” table 4. Edit the table to match the panel a. For TTD or DD40, this table should match the shutdown legend exactly b. For a DE3000, this table will match the channel list c. For a centurion, th...")
Symptom: Callouts are being sent normally but the description is not correct
Verify Fault Code Table
1. Connect to the EDR wifi console. Instructions can be found here: EDR Wi-Fi Console
2. Go to the “Alerts” tab of the console
3. Open the “Shutdown Code” table
4. Edit the table to match the panel
a. For TTD or DD40, this table should match the shutdown legend exactly
b. For a DE3000, this table will match the channel list
c. For a centurion, the shutdown enumeration table is found in the programming document for the specific drawing number. This can be obtained from Murphy.
