EIM System Settings or Utilities Pages: Difference between revisions
Line 24: | Line 24: | ||
=== Software Update === | === Software Update === | ||
The "Software Update" page is used to update the software on the EIM. | The "Software Update" page is used to update the software on the EIM. See [[EIM_Software_Update]] | ||
=== Clean Screen === | === Clean Screen === |
Revision as of 19:05, 6 July 2023
System Settings / Utilities Pages
The "System Settings / Utilities" Page, accessed from the EIM home screen, contains several back pages for system settings. A description of each is below, or a reference to another article if it exists.
About
The About screen (Pg. 4) displays the serial number, hardware version, and software version of the EIM and each module connected to the EIM.
Touchscreen Calibration
The touch screen can be re-calibrated if it is determined that button selection appears to be offset from what is displayed on the screen. To calibrate the touch screen:
- Enter Engineering security access mode
- Navigate to the About screen (Pg. 4)
- Select the “Calibrate Touch Screen” button to start the calibration application
- Very carefully, use quick motions to touch each crosshair as they appear on the screen
- After the calibration, the screen will return to the About screen (Pg. 4) and display a confirmation box that must be accepted
- If the confirmation box is not accepted, the touch screen will omit the new calibration data
For accuracy when selecting the crosshairs, it is recommended that you use a stylus, such as the blunt end of a pen, rather than using your finger.
Use caution not to double tap or select each crosshair as it will result in a bad calibration. The best method to not double tap is to select the crosshair in one quick motion.
Go To Page
The "Go To Page" screen can be used to navigate to a page by the page number. Each page shows a page number at the top of the screen.
Software Update
The "Software Update" page is used to update the software on the EIM. See EIM_Software_Update
Clean Screen
The "Clean Screen" page shows a blank screen so that the touch screen can be cleaned with a cloth without pressing any buttons.
Main Help
The main help button goes to the help module of the EIM. This is the same as the "Help" button on the EIM home screen.
MODBUS
The "Modbus" page is for setting up the Modbus connection. See article EIM Modbus RTU
Config Files
See EIM Config Files
Reset
In Engineering security mode, the system can be reset to the factory default values within the Reset screen (Pg. 5) of the EIM. Press the “Reset AFRC, EMD, EIM” button to reset those modules to factory defaults. Press the “Reset ICM” button to reset the Ignition to factory defaults. After reset the Ignition will be in “Configuration Required” state until ignition setup is completed.
Datalog Files
This page can be used to download or delete the datalog files. For more information, see the article "EIM Datalogging".
Home Background
This page can be used to add a background watermark to the EIM home page.
Troubleshooting File
The EIM can accept a custom troubleshooting file for showing troubleshooting trees for certain shutdown conditions. This file will usually be supplied by EMIT and uploaded on this page.
Change Setup Password
This page is used to change the setup password.
Ethernet
This page is used to change ethernet settings. See EIM Ethernet