Annunciator Testing Mode

The Brain has a timed test mode that is used while the engine is running to test faults without shutting down. This page is accessed from the main setup by going to Brain -> “Testing Mode”.

Note: If the unit is not running, inputs can be tested at the Annunciator Fault & Output Status Screen instead.

Test Mode Page

On the page the testing mode can be started or stopped. When started, the test mode will run for 5 minutes, or until it is stopped. During testing mode the unit will not shut down for any A, B, or C class faults. The faults will still be shown on the Inputs and Timers Status page to verify the fault is operational. Any ESD class inputs will still cause the engine to be shut down when faulted.

Selecting the button "Previous fault times" will go to the Previous Fault Times page, which shows the previous time an input was faulted for any reason, whether in test mode or not.