New pages
From EMIT Controls
- 19:59, 13 March 2024 EDT stand alone table (hist | edit) [281 bytes] Thomas Peterson (talk | contribs) (Created page with "The EDT module (20350) can be used in a stand alone capacity to translate engine data to modbus without use of an EMIT screen. The Modbus list is found here: [https://drive.google.com/file/d/12hMzQQbGhOkUW418gLoFQXhgKTfeQOfM/view?usp=sharing]")
- 17:31, 16 February 2024 Waukesha VHP Engine Controls (hist | edit) [6,951 bytes] Thomas Peterson (talk | contribs) (Created page with "== Overview == EMIT engine control products (AFRC, Ignition, and speed controller) can be used on Waukesha VHP engines of various types. These kits can replace the ESM or upgrade older engines. This page covers ordering, install, and operating information. == Ordering Information == The sections below show what AFRC, Ignition, and governor kit would be selected for different applications, and the item numbers for spare parts. === AFRC === Note that the kit item numb...")
- 18:19, 15 February 2024 Panel to ESM(r) Interfacing (hist | edit) [6,409 bytes] Thomas Peterson (talk | contribs) (Created page with "== Overview == The Waukesha ESM (r) is an engine control unit made by Waukesha for their VHP series engines. When a unit with an ESM is connected to an EMIT panel, the panel will use a few signals to control the start, stop, and speed of the engine. Many concepts are similar to connecting to other engines. === Initial Setup === Navigate to Settings - Brain - Outputs Setup - ECU Selection, and select "Waukesha ESM". == Panel to ESM Connections == There are three disc...")
- 17:40, 31 January 2024 Vibration Sensor CAN Wiring (hist | edit) [981 bytes] Thomas Peterson (talk | contribs) (Created page with "The EMIT vibration sensor can be wired as a 4-20mA sensor or using a CAN bus. Benefits of using the CAN bus are (1) the panel analog inputs won't be consumed and (2) more detailed data and information will be available. As mentioned in the Vibration Sensor Manual, to wire via CAN the connection must make a single daisy-chain from the panel to each sensor. If a sensor is the end of the chain (only one wire goes into each terminal) then the red termination switch wil...")
- 17:36, 31 January 2024 Vibration Overview (hist | edit) [2,044 bytes] Thomas Peterson (talk | contribs) (Created page with "asdf") Tag: Visual edit
- 21:25, 5 January 2024 EDR Loopback Test (hist | edit) [1,414 bytes] Thomas Peterson (talk | contribs) (Created page with "A loopback test involves setting up the EDR to communicate from its own master to slave port. This tests that both ports are functional. ==Test Instructions== * Disconnect any wires in the EDR pins 3-8 and set aside. (We recommend taping over the wires so they don't short to anything) * With two spare short wires, connect 4-7 and 5-8 600px * Connect to the EDR wifi (See here for instructions) * On the "Modbus Mas...")
